PRINTING • Use the multi-function tray (if applicable). • Air all sheets on both edges to make sure they are loose. • Do not stack more than 30 sheets at a time. • Ensure all sheets are stacked. • Set paper type: Label, Transparency, or Heavy Paper mode. • Do NOT use Mirror Image setting; otherwise, image will not read correctly after application. • Open the feed option from the back of the printer for straight feed through the printer (if applicable).
APPLICATION • Apply a generous amount of the U/V sealant spray onto the Translide® Clear laser transfer paper, and allow to dry. • Follow the U/V sealant spray manufacturer instructions carefully. • Make sure that this procedure is performed in an open and ventilated area. • Allow the U/V sealant to dry. • Cut out the imaged area, and submerge the decal into lukewarm water for 30 seconds. • Slide the image off of the carrier sheet and place onto the substrate. Position the decal as required. • Remove any water or air from the decal by using a soft piece of paper or a rubber squeegee.
DRYING • Dry the decal by using a hair dryer. • If applying onto ceramic, metal, wood or glass, place the substrate into an oven and bake at 300ºF for 30-120 minutes.